|
|
|
|
WL-T6 WLtoys Adaptador de banda
frecuencia 2.4Ghz
Válido para helicopteros V922, V933, V944 y V955, así como
emisoras JR, Futaba y Walkera. |
|
|
|
|
-
Marca y Modelo: WL-T6. 0Adaptador
que permite usar emisoras FLY SKY, FUTABA, TURNIGY, JR Y WALKERA
con helicópteros WLTOYS y otras marcas.
-
Material: plástico respetuoso del medio ambiente, metal y componentes electrónicos
-
Disponible en alimentación interna y fuente de alimentación externa
-
Ampliamente aplicable para mandos a distancia de V922, V933, V944 y V955 helicópteros, así como JR, Futaba y helicópteros Walkera
-
3.7 150mA batería de litio 15C:
BaterÃa incluida dentro del adaptador de modulo de frecuencia.
-
Voltaje de funcionamiento: CC 5-12V
-
Corriente de funcionamiento: ≤100mA
-
Frecuencia de funcionamiento: 2402MHz-2477MHz
-
Modo de espectro de frecuencia: FHSS
-
Número de canales de frecuencia: 20
-
Hopping tasa: 240 Saltos / S
Normal Use Operation:
1. Supplying power of radio itself(eg:JR/Futaba) the HT-8 internal power
supply switch to OFF state.ProperLy connected HT-8's signal cables and power
cables.(JR signal cable connecting the remote control DSC intertace,and
power cable to connect to DC charging port)(Futaba's connection is a
combination of signal cable and power cable to connect simulator interface).
2. IF no power from radio,switch the HT-8 internal power supply to on
state,properly connected HT-8 and remote control of the DSC interface.
3.Under normal circumstances the HT-8 light is green,when red check the
signal cable if is normal,as well as check the remote control to set the
modulation mode to PPM format.Set the types of remote control through switch
the button of high- frequency head,the status indicator (Model),Futaba (green)
JR(red).WAKERA (not light).
Charging Operation:
First put the internal power switch to OFF position,no LED lights on RF
Module bright this time,then connect RF Module to a computer(or the other
power supplier equipment) using USB wire.Signal indicator light starts to
flash and Mode indicator light shows charging status:red means
charing,turning to green means charging is over. |
|
|
|
New HiSKY HT8 Adapter Module For JR Futaba Transmitters FBL100 Description: Remote Control-Shatter Resistant Type: Helicopter State of Assembly: Ready-to-Go Material: Metal-Plastic-Fiberglass Power Source: Electric Length: 60mm Height: 35mm Weight: 200g Battery: 3.7V 150mAh 15C Li-Poly Flight time: 4 to 5 minutes Charging operation: First put the internal power supply switch to OFF position-no LED lights on RF Module bright this time-then connect RF Module to a computer (or the other
power supplier equipment)using USB wire-this time-Signal indicator light starts to flash and Mode indicator light shows charging status:red means charging-turning to green means charging is over. Nomal use operation: 1.supplying power of radio itself (eg:JR/Futaba) the HT-8 internal power supply swith to OFF stare.Properly connected HT-8's signal cables .(JR signal cable connecting the remote control DSC interface-and power cable to cnnnect to DC charging port)(Futaba's connection is a c
ombination of signal cable and power cable to connect simulator interface). 2.If no power from radio-switch the HT-8 internal power supply to on state.Properly connected HT-8 and remote control of the DSC interface. 3.Under normal circumstances the HT-8 light is green-when red check the signal cable if is normal-as well as check the remote control to set the modulation mode to PPM format-Set the types of remote control through switch the button of high-frequency head-the status indicator o
f remote control through switch the button of high-frequency head-the status indicator (Model)-futaba(green) JR(red).WAKERA (not light). Notice: 1.There is one 3.7V Li-po Battery sealed in the RF Module. If the redio controller you use can supply the power to the RF Module- please turn off the sealed battery to off status. 2.Please pay attention to the battery power when you use sealed battery of RF Module- if the green light is flashing- please stop to play and charge the battery. HT8 Radio A
DAPTER Parameter: Sealed battery specification:3.7V Li-Po battery 120mAh Operating voltage:5-12V. DC Operating current:<100mA Operating Frequency:2402 MHZ-2477 MHZ Spread Spectrum mode:FHSS Number of frequency channels: 20 Hoping Rate: 240 Jump/s Package included: 1 x New HiSKY HT8 Adapter Module 1 x Battery 1 x Charger cable 1 x Simple manual"
De momento no hay ninguna opinión.